probst POWERPLAN PP, Operating Instructions Manual, Page: 58 / 230

Operating Instructions
PP Maintenance and care
57 / 73
V4 GB
6.3.1 Dry-cleaning with compressed air
Only dry-clean the machine with compressed air if it is only lightly soiled with dry dust.
6.3.2 Cleaning the machine with water and detergents
If the machine is only lightly soiled with dust, oil and fuel:
•
Only use neutral or alkaline detergents.
•
Apply detergent with a brush, leave to soak and hose off with water.
•
After cleaning, lubricate the machine. See “Lubrication”.
6.3.3 Cleaning the machine with a pressure washer
If the machine is heavily soiled, including with oil and fuel:
•
Keep t he pressure washer’s nozzle at least 300 mm away from the machine.
•
The pressure washer’s jet pressure must not exceed 100 bar.
•
The water jet temperature must be 80-90 °C.
•
Only use neutral or alkaline detergents.
•
Use a brush or a similar aid to remove solid dirt deposits.
•
After cleaning, lubricate the machine. See “Lubrication”.
6.3.4 Cleaning the outside of the engine
•
The cleaning methods listed below should be used depending on the level of soiling.
•
Protect electronic components and seals from direct contact with water.
•
Leave the engine running until it gets warm after cleaning to allow residual water to evaporate and prevent the
formation of rust.