Pro Mach Orion CTS Flex Stretchwrapper, Manual

Page: 79 / 132

Orion Machine Manual
Revision 3.0 CTS Flex Stretchwrapper
25 July 2016 System Operation
Page 3-49
CLAMIPING &
CUTTING FILM
The machine is now in the clamp and cut cycle.
This is for informational pur-
poses only. No correction neces-
sary.
INITIALIZING
The machine is initializing.
There is a brief initialization
sequence once the machine is
reset. Allow the machine to ini-
tialize prior to starting.
LIGHT CURTAIN
BLOCKED
The light curtain is blocked (if equipped.)
Clear the obstruction from the
light curtain to allow operation.
SAFETY SYSTEM NOT
READY
The safety controller is not ready to run.
Allow the safety system to ini-
tialize prior to running.
FAULTS EXIST
Faults currently exist.
Correct the cause of the fault.
Press reset to reset the fault con-
dition once the cause is cor-
rected.
CARRIAGE MOVING
UP TOO SLOWLY
The carriage is moving upward too slowly.
Check for the cause of the car-
riage not moving correctly.
Check the belt drive behind the
back panel. Check for a jam or
obstruction on the track.
CARRIAGE MOVING
DOWN TOO SLOWLY
The carriage is moving downward too slowly.
Check for the cause of the car-
riage not moving correctly.
Check the belt drive behind the
back panel. Check for a jam or
obstruction on the track.
BRUSH AND CUTTER
NOT HOME
The brush and cutter are not home.
Cycle the brush and cutter.
Check why the brush and cutter
can’t reach the home position.
MULTISTRETCH VFD
NOT READY
The indicated VFD is not ready to run.
Check the fault code on the VFD
display in the electrical cabinet.
See VFD manual for fault code
information.
MAIN DRIVE VFD NOT
READY
CARRIAGE VFD NOT
READY
Table 3-32. The Information and Alarm Displays (Continued)
MESSAGE DESCRIPTION CORRECTION