Pro Mach Orion CTS Flex Stretchwrapper, Manual

Page: 18 / 132

Machine Manual Orion
CTS Flex Stretchwrapper Revision 3.0
Introduction and Safety 25 July 2016
Page 1-8
Maintenance Safety
The following safety precautions are recommended for all personnel who are responsible
for the maintenance or service this CTS Flex Stretchwrapper.
• Personnel should ensure that all safety devices are functioning and periodically
checked for proper operation before performing maintenance.
• Before performing any maintenance, service, or inspection inside the main control
panel, the power source should be turned off and locked out.
• Maintenance should be performed on the system with the power OFF. Lockout and tag
out procedures should be followed to protect personnel from injury and to indicate the
equipment is being serviced.
• Place a lock on the main electrical disconnect, as shown below, while performing
maintenance.
• Personnel should pay careful attention to all devices that may be powered or capable
of motion, such as conveyors and pneumatic devices.
• Release or block all stored energy devices (hydraulic or pneumatic) that may present a
danger when working with the system. Before working with pneumatic devices, shut
off the air supply and purge the air lines.
• Be aware when removing a servomotor or brake that the associated mechanical part
will fall unless supported in some manner.
• Use only specified replacement parts. Never use non-specific fuses that have not been
specified. Potential fire and/or damage may result.
• Before restarting the system, ensure personnel are not in the system and that the sys-
tem and external devices are operating properly.