Pro-face PS5000 Series, User Manual

Page: 46 / 148

Slim Panel Connections
46
Wiring and Connecting the Terminal Block
The table below describes how to connect the power cord to the DC terminal block of the Slim
Panel:
Step Action
1 Remove all power from the Slim Panel and confirm that the power adapter is disconnected from
its power source.
2 Remove the terminal block from the power connector and connect the power cord to the terminal
block:
Use copper wire rated for 75 °C (167 °F) with a section of 0.75 to 2.5 mm
2
(AWG 18 to AWG 14)
and use 2.5 mm
2
wire to make the ground connection.
3 Place the terminal block in the power connector and tighten the screws:
NOTE:
The recommended torque to tighten these screws is 0.5 Nm (4.5 lb-in).
CAUTION
OVERTORQUE AND LOOSE HARDWARE

Do not exert more than 0.5 Nm (4.5 lb-in) of torque when tightening the installation fastener,
enclosure, accessory, or terminal block screws. Tightening the screws with excessive force
can damage the installation fastener.

When fastening or removing screws, ensure they do not fall inside the Industrial Personal
Computer chassis.
Failure to follow these instructions can result in injury or equipment damage.