Operating instructions
wheel-e
24
The contacts of the rechargeable batteries
must not be short-circuited. A short-circuit
causes very high currents which could damage
the rechargeable batteries and/or the product.
The product's rechargeable batteries may
only be charged using the original charger from
the manufacturer which was supplied. They
can be charged in any position.
The charger may only be used under dry
conditions. Protect it from rain and humidity,
fire and high temperatures. Avoid temperature
fluctuations that can cause condensation.
During the charging process, the charger
may not be covered with any objects.
Do not try to force the rechargeable
battery out of the holding rail using the locking
lever. This can cause damage to the
connection plug.
Never unplug a connection when the
system is switched on. This can cause the
components to malfunction. In case a
rechargeable battery was removed while the
system was switched on, wait for 5 minutes
until the system is switched off and then
reinsert the rechargeable battery. 5 successive
beeps indicate that the rechargeable battery
has switched itself off and you can use it safely
again.
21.5.2 Change plug connection as a
switching solution for double
rechargeable battery
On the BionX drive system, the change plug
can be switched between both rechargeable
batteries "Rechargeable battery 1" and
"Rechargeable battery 2".
The following figure shows the initial position of
the change plug connection when
Rechargeable battery 1 is connected. In doing
so, the slider is at position "Rechargeable
battery 1". This position is visible when the
arrow on the rail points to "Rechargeable
battery 1". The eccentric lever is in the locked
position.
Figure 36: Initial position "Rechargeable battery 1"
connected with eccentric lever in locked position
In order to switch from Rechargeable battery 1
(when it is empty) to Rechargeable battery 2,
first switch off the drive system in the display
and then move the eccentric lever over to the
switching position (or unlocked position).
Figure 37: Eccentric lever in the switching position
When the eccentric lever is moved over, now
you can move the slider to position
"Rechargeable battery 2". Move this until you
can feel it at the end stop. Now the arrow on
Eccentric lever in
the locked position
Move the
eccentric lever
into the
switching
position
Slider to
position
"Re-
chargeable
battery 1"
Arrow at
"Re-
chargeable
battery 1"
Arrow at "Rechargeable battery 1"
Slider to
position
"Rechargeable
battery 1"
