Operating instructions
wheel-e
22
Figure 28: Display with support level 2 set
Figure 29: Display with support level 4 set
When setting the support level, it must be
noted that the range of the rechargeable
battery decreases when higher support levels
are used.
After the support level has been set, the
driving signal transmitter
(throttle grip)
regulates the speed from 0 km/h up to the
maximum speed. To accelerate, turn the
driving signal transmitter against the direction
of travel, i.e. towards the body. To reduce the
acceleration, turn the driving signal transmitter
in the direction of travel or away from the body.
Figure 30: To accelerate, turn the driving signal
transmitter against the direction of travel (the picture
shows the driving signal transmitter mounted on the
right)
When driving in curves, reduce your
speed to a minimum and if possible, lean your
upper body towards the curve.
21.4.3 Recuperation (rechargeable battery
re-charging)
When the product is equipped with a hydraulic
disc brake, the
brake lever
with the brake
sensor is mounted on the right (on the same
side as the driving signal transmitter). When
you actuate this brake lever, the support is
automatically interrupted and simultaneously
switched to recuperation mode.
When driving down a longer slope, you can
regulate the speed by switching to a
permanent recuperation level
. To do so,
press "
–
"
to switch to recuperation mode.
Here, you can select between 4 levels. Select
a higher recuperation level if you want a
stronger braking effect.
Figure 31: Display with recuperation level 2 set
21.4.4 Inserting or replacing the display or
the operating console
To
insert the display
, push the display into
the corresponding clip on the handlebar. Make
sure that the display latches firmly into the clip
on the handlebar.
Accelerating
Support level 4
Support level 2
Recuperation level 2
Direction of travel
Support levels
Recuperation levels
