Operating instructions wheel-e
17
21.1.2 Parking stand height adjustment
The height adjustment of the parking stand is
important in order to bring the docking plate of
the product into the correct (heigh) position to
the adapter.
For setting the height of the parking stand, the
following must be observed: the dimension
from the floor to the lower edge of the front of
the insertion maul (on the wheelchair side)
should correspond with the dimension from the
ground to the upper edge of the insertion bolt
(on the product side). As soon as there is a
deviation from these two dimensions due to the
hole pattern, the dimension from the ground to
the upper edge of the insertion bolt may be up
to max. 1 cm larger. In this case, the product
can be inserted into the adapter by tipping
slightly to the rear (via the parking stand).
Figure 14: Measurement from the ground to the
lower edge of the front of the insertion maul
Figure 15: Dimension from the ground to the lower
edge of the insertion bolt
Figure 16: Position of the product and wheelchair
with the parking stand height adjustment set
correctly
The
height of the parking stand
is adjusted
by unscrewing the M6 oval head screw
(AF 4 mm) with the washer and repositioning
the adjustment inlet along the specified row of
holes in the parking stand and inlet. Finally,
tighten the oval head screw up to 7 Nm of
torque.
Front of the
insertion
maul
Dimension
from the
ground to
the lower
edge of the
front
Insertion
bolt
Dimension from
the ground to
the upper edge
of the insertion
bolt
