Printronix Integrated Network Interface Card, User Manual

Page: 35 / 310

Wireless NIC Configuration Using The Control Panel
31
WPA Parameters
•
WPA Mode . Selects the WPA wireless security mode. By
default the mode is set to Disable thus disabling WPA security.
If set to Personal, this selects a personal or pre-shared key
mode for WPA security.
•
WPA Cipher . Selects the WPA wireless security cipher setting.
•
WPA P-Phs . Sets the individual bytes of the WPA passphrase.
•
Reset WPA P-Phs . Resets all 32 bytes of the WPA
passphrase at once.
LEAP Parameters
LEAP wireless security scheme is available when the Cisco Aironet
350 radio card is installed. The Cisco LEAP allows for a WEP key
timeout that forces re-authentication, resulting in the derivation of a
new WEP key for the session.
•
Auth Method . This feature allows the user to select the
authentication method used for the wireless network interface.
•
Open (the default). Selects open authentication.
•
Shared . Selects shared key authentication.
•
Kerberos . Selects Kerberos authentication (for use when a
Symbol RF card is installed).
•
LEAP . Selects LEAP authentication (for use with a Cisco
RF card installed).
•
LEAP Username
•
LEAP Username (01-15) . The first 15 characters of the
LEAP user name (maximum number of characters is 32).
•
LEAP Username (16-30) . Characters 16 to 30 of the LEAP
user name (maximum number of characters is 32).
•
LEAP User (31-32) . Characters 31 to 32 of the LEAP user
name (maximum number of characters is 32).