37
for irregular shaped labels, circles larger than 4 inches or on any stock where the print starting
position cannot be sensed using the label itself.
Continuous. (Sensor off)
If you have continuous stock with no die-cut, reflective mark or holes, set
the sensor type to Continuous. This will turn off the stock sensor. In this mode there is no way to set
the print starting position. The printer will simply start printing the first label and print each
subsequent label immediately after that previous one. To produce a gap between prints simply add
the desired amount of white space to the end of the label being printed. The printer will
automatically switch to this setting when Digital Die Cutting Label Stock is installed.
Important Note:
You must also set the Stock Sensor Position (Section 2G)
