P r i m a L u c e L a b i S r l
E AG L E 3 U s e r M a n u a l
Now you have to set remote access parameters in Remote Desktop software installed in the device you want to control
EAGLE from. First of all you need to verify what is the IP address your router assign to the EAGLE when you use the HOST
feature and this may vary based on your network configuration. In order to do this, in the EAGLE please type “cmd” in the
“Search Windows” bar (bottom left part of the Window) and press ENTER in the keyboard. This will open a new window.
Please type “ipconfig” and press ENTER again. You will see a line with the IP number of your EAGLE connected to your
network (please take a look at the picture below). This is the IP number you have to write in Remote Desktop when you
want to connect to EAGLE by using the HOST feature.
You have to insert this address in the options of “Remote Desktop” software (ima-
ge 33) in the device you use to control the EAGLE from (please see page 8 of this
user manual), instead of 192.168.137.1 as previously set. Click on Save to save
software connection options. Going back to main page you will find a new connec-
tion. Connect your computer (or other device) you use to control the EAGLE from to
the same WiFi network you connected EAGLE and click on the new connection just
created in the “Remote Desktop” software to start remote connection to EAGLE.
p a g e
!
3 0
Image 33: Remote Desktop con-
nection settings
ATTENTION!
Make sure that you entered the correct network parameters (especially your network password) because,
if they are wrong, EAGLE will not be able to access your network and at the same time it will not create
its network in Access Point mode: in this case you won’t be able to connect to EAGLE anymore and you
will need to click its RESET button to reset the network.
Tip:
if during the use of the EAGLE you can no more access to its WiFi network, both in AP and HOST mode,
press the RESET button on the left of the POWER button on the EAGLE case. This will reset WiFi network
in AP mode. Then, in the device you use to control EAGLE from, you have to select the WiFi created by
the EAGLE (EAGLE2XXXXX) and restart Remote Desktop software.
