Precor Experience 800 EFX, Getting Started Manual

Page: 9 / 34

7
WARNING DO NOT allow cables to touch any moving parts around the lift motor body—lift screw, yoke, or ramp. Run
the ramp through its movement path a few times and have someone else watch to make sure no cables are
caught up or hanging loosely.
Depending on the site location and distance from an outlet, you might need to route the power supply either internally (below) or externally (see page 8).
To route the power supply internally:
1. Hook the Power Supply Bracket* onto the right upright support
(see Figure 4a).
* Included only in touchscreen console boxes
2. Coil up all cables—coax, power extension , and Ethernet—and hold
the power supply on the holder with one hand, and with the other
hand, thread a large zip tie around the upright support (see Figure 4b).
Note Make sure you thread the zip tie through the designated slots
in the power supply bracket .
3. Pull the zip tie tight only after you have reduced any slack by pulling
the cables tighter from the top.
4. Insert the grounding jumper in to the ground connector, and then
secure the cables inside each of the three cable clips attached to the
right upright support. Leave cable connectors loose until after the
lower panel is installed ( s ee page 9).
Figure 4a
Figure 4b
To complete the console installation, refer to the installation guide shipped with your console.