Precor Experience 800 EFX, Getting Started Manual

Page: 19 / 34

Monthly Maintenance Tasks
Perform all checks listed under Weekly Maintenance Tasks plus the following:
For all equipment
•
Verify the Wireless Heart Rate feature is performing properly by following the procedure, Verify that the heart rate feature works, in this Guide.
•
Remove plastic enclosures from the drive compartments and remove any lint or debris, and then do the following in order:

Clean the drive belts and pulleys with a small wire brush.

Vacuum out any debris, being careful not to bring the vacuum cleaner nozzle too close to any circuit board. Precor recommends you use a vacuum that protects
against static buildup.

Inspect visible welds, frame, and wire connections.

Check all fasteners for proper tightness and torque.

Treadmill, elliptical, and AMT only Clean and lubricate the lift motor screw with an approved grease such as SuperLube® with Teflon or Mobil 1™ synthetic
grease, if necessary.

Treadmill only Verify the power cord clamp is securely installed.

Replace all removed plastic enclosures.
•
Treadmill only Visually inspect the running deck and belt. Make sure the deck and belt are in good condition and replace the belt, if necessary.
•
Elliptical only

Verify that the wheels run smoothly on the CrossRamp®.

Check all wheels for wear or cracks.

Lift the badge plate from the bottom front to loosen the rubber gasket. Remove the gasket (at the split) from the back of the display mount. Clean debris then
replace the gasket from back to front, aligning the tabs as you go.
DO NOT pull the gasket ring off before removing the badge plate first.
•
AMT and climber only Inspect support belts and pulleys for wear or damage. Check torque on belt clamps.
•
All equipment except treadmill Verify pedals move smoothly and freely in all directions.
•
Bikes only Verify that the seat moves through the entire adjustment range and that the position latch works correctly.
•
For treadmill only Clean the underside of the running belt and top deck by following the procedure, Clean the running belt and deck in this Guide or visit us at
www.precor.com .
5