Precor Experience 800 EFX, Getting Started Manual

Page: 7 / 34

5
Begin assembly
DANGER DO NOT attempt to connect electrical power until all assembly procedures are complete and the console is properly installed.
To install the console mount:
Before you begin this procedure, retrieve the electrical and communication cables for
the console that you plan to install on this EFX. These cables are shipped with the
console.
1. Position the display mount on top of the base frame and attach it using the four
bolts (see Figure 2). Fully tighten all bolts (torque=180 in-lbs, 20 N-m).
Figure 2
2. For touchscreen consoles: Group all four cables--communication, coax, power
extension supply, and Ethernet--and thread them upward through the center
column and out through the center opening in the console mount. Tape it to the
top of the console mount to secure it temporarily.
Note For non-touchscreen consoles,the communication cable is pre-threaded.
Important DO NOT stretch, crimp, or damage the cable.
Cables damaged by improper installation will not be covered by the Precor Limited
Warranty.