8
WARNING
DO NOT allow cables to touch any moving parts around the lift motor body—lift screw, yoke, or ramp.
Run the ramp through its movement path a few times and have someone else watch to make sure no cables are caught up or
hanging loosely.
To route the power supply externally:
1.
Coil up all cables—coax, power extension
, and Ethernet—and hold them
in
place with one hand, and with the other hand, thread a large zip tie around
the
upright support (see Figure 5).
Note
Make sure you thread the zip tie through the designated slots in the
power supply bracket .
2.
Pull the zip tie tight, making sure you have enough slack in the power and
extension cable.
3.
Insert the grounding jumper in to the ground connector, and then secure the
cables inside each of the three cable clips attached to the right upright
support. Leave cable connectors loose until after the lower panel is installed
(see
To install lower panel and front cover
).
Figure 5
To complete the console installation, refer to the installation guide shipped with your console.
Summary of Contents for Experience 800 EFX
