Precor EFX 524I, Owner'S Manual

Page: 53 / 60

EFX524i Elliptical Fitness Crosstrainer Assembly Guide 3
Assembly Steps
Feed the display cable through the upright support.
Important: Do not stretch, crimp, or damage the cable. Cables
damaged by improper installation will not be covered by the
Precor Limited Warranty.
Feed the heart rate cable through the hole in the handrail bracket
and out through the clamp. Make sure a female connector exits
through the left opening and a male connector exits through the
right opening.
Attach the display console to the upright support using four
Phillips-head screws (A).
Thread the display cable through the grommet and out the front
of the base tube. Plug the cable connector into its receptacle.
Important: If the plastic grommet pops out of the base, replace
it immediately. The grommet covers the metal edges so the
cables are not cut or damaged.
Disconnect the lift motor connector from its receptacle. Thread
the receptacle through the cutout in the upright support.
Reconnect the cables and rest the upright support on the base.
Align the mounting holes and secure the upright support to the
base using two hex head screws (C) and two washers (D).
Finger tighten.
Push excess cable into the base tube.
CAUTION: Be aware of a sharp screw inside the base tube.
Abrasive cuts or other injuries can occur if you place your
hands, fingers, bare feet, or toes inside the base tube.
Lift the EFX. Slide a wedge of packing material under the front of
the unit.