Precor EFX 524I, Owner'S Manual

Page: 54 / 60

EFX524i Elliptical Fitness Crosstrainer Assembly Guide 4
Remove two Phillips-head screws from the underneath of
the upright support bracket. Align the lift cover and
reinstall the screws. Wrench tighten.
CAUTION: Do not over-tighten the screws or you may
cause stress cracks in the plastic.
Thread the hex nut and height adjuster into the base.
Wrench tighten the nut.
Attach the upper portion of both stabilizers to the upright
support bracket using eight hex head screws (C) and
eight washers (D). Finger tighten.
Attach the lower portion of both stabilizers to the base
frame using eight hex head screws (C) and eight
washers (D). Wrench tighten.
Return to the upright support bracket. Wrench tighten the
eight screws that secure the stabilizers to the bracket.
Wrench tighten the two screws holding the upright
support onto the base. Refer to Step 6.
Use the
³⁄₁₆
-inch hex key to loosen the two fasteners in the
handrail clamp.
Important: Ask your assistant to hold the handrail close
to the unit while you perform steps 16 and 17.
Connect the heart rate display cables to the handrail
cables. Place excess cable inside the handrails.
Insert the handrails into the upper clamp. The foam on
each handrail should be touching the handrail clamp.
Attach the handrail base to its bracket using four hex head
screws (C) and four washers (D).
Wrench tighten all six handrail fasteners.
To prepare for the installation of the side covers, remove
four Phillips-head screws from the base near the lift motor.