C576i Self Powered Elliptical Fitness Crosstrainer
Page 61
5.
Remove the ramp from the EFX.
6.
Remove the two screws that fasten the rear ramp end cap to the ramp. Set the rear ramp
end cap at its mounting position on the replacement ramp and fasten with the screws
removed above.
7.
Set the replacement ramp in its mounting position and hand start ramp pivot mounting bolts
removed in step 3. Do not tighten them at this time.
8.
Slide incline yoke into its mounting position in the ramp and fasten it with the hardware
removed in step 4.
9.
Apply blue loctite to the four ramp pivot bolts (hand started in step 7) and torque them to 480
inch pounds (40 foot pounds).
10. Slide the stairarm onto the crankarm and set the stairarm in its ramp track. Fasten the
stairarm to the crankarm with the retaining ring removed in step 7.
11. Slide the large black spacer onto its mounting position on the stairarm. Slide the steel
spacer into the end of the stairarm connector. Fasten the stairarm connector to the stairarm
with the bolt, removed in step above, and a washer on each side of the steel spacer in the
end of the stairarm connector.
12. Align the T-nuts on the ramp trim(s) with the channel in the bottom front of the ramp. Slide
the trim onto the ramp while feeding each T-nut into the ramp channel. Do not tighten the
trim fastening screws at this time. Repeat this procedure with the remaining trim strip, if
required.
13. Set the ramp end cap at its mounting position and fasten it with the screws removed in step
3.
14. Align the ramp trim(s) with the ramp end cap and tighten the five trim mounting screws.
15. Set the ramp center cover at its mounting position and press downward to snap it onto
place.
16. Replace the lift cove per Procedure 7.2.
