C576i Self Powered Elliptical Fitness Crosstrainer
Page 52
Procedure 7.10 - Replacing the Input Pulley Assembly
WARNING
Before continuing with this procedure, review the Warning and Caution statements listed in
Section One, Things You Should Know.
1.
Remove the left and right side rear covers per Procedure 7.1.
2.
Remove the stairarm assemblies as described in Procedure 7.14.
3.
Remove the crankarm assemblies as described in Procedure 7.7
4.
Remove the input pulley assembly mounting nuts (2 per pillow block bearing).
5.
Straighten the locking tabs and turn the left and right tension bolts counterclockwise until
tension is removed from the both belts. (Refer to Diagram 5.2)
Diagram 7.10 - Input Pulley Assembly
6.
Remove the input pulley assembly. Slide input pulley belt off of the input pulley assembly.
7.
Hold the replacement input pulley assembly at it’s mounting position and slide the input belt
over and past the pillow block bearing and onto the input pulley assembly.
8.
Replace the nuts on the pillow block bearings and torque them to 400 inch pounds.
Pillow
Block
Bearing
Input
Pulley
Assembly
Crankarm
