C576i Self Powered Elliptical Fitness Crosstrainer
Page 42
7.
Reconnect the lower PCA cables and wiring as follows. Connect the interconnect cable to
connector J2. The 2 conductor cable (red and black wires) from the input power jack to the
J4 connector. The 6 conductor cable from the generator to connector J1.The 6 conductor
cable from the incline motor to connector J5. From the battery, connect the red wire to M6
and the black wire to M7 of the lower PCA. Connect the two leads from the load resistors to
M1 and M2, the polarity of the load leads is not critical, either lead may be connected to
either the M1 or M2 terminal.
8.
Remove the ground lead of the wrist strap from the EFX frame, then remove the wrist strap
from your arm.
9.
Re-install the rear cover, then check the operation of the C576i as described in Section
Four.
