C576i Self Powered Elliptical Fitness Crosstrainer
Page 59
9.
Remove the retaining ring that fastens the stairarm to the crankarm and remove the stairarm
from the EFX.
10. Remove the stairarm pedal per Procedure 7.13 and install it on the replacement stairarm.
Refer to Procedure 7.13.
11. Remove both wheels and slide them onto the replacement stairarm’s axle. Apply blue loctite
to the wheel mounting screws and torque the wheel mounting screws to 180 inch pounds.
12. Slide the stairarm onto the crankarm and set the stairarm in its ramp track. Fasten the
stairarm to the crankarm with the retaining ring removed in step 7.
13. Slide the large black spacer onto its mounting position on the replacement stairarm. Slide
the steel spacer into the end of the stairarm connector. Fasten the stairarm connector to the
stairarm with the bolt, removed in step 6, and a washer on each side of the steel spacer in
the end of the stairarm connector.
14. Align the T-nuts on the ramp trim(s) with the channel in the bottom front of the ramp. Slide
the trim onto the ramp while feeding each T-nut into the ramp channel. Do not tighten the
trim fastening screws at this time. Repeat this procedure with the remaining trim strip, if
required.
15. Set the ramp end cap at its mounting position and fasten it with the screws removed in step
3.
16. Align the ramp trim(s) with the ramp end cap and tighten the five trim mounting screws.
17. Set the ramp center cover at its mounting position and press downward to snap it onto
place.
18. Replace the lift cover per Procedure 7.2.
19. Replace the stairarm cover(s) with the hardware removed in step 2.
20. Replace the left and right side covers per Procedure 1.
