C576i Self Powered Elliptical Fitness Crosstrainer
Page 58
Procedure 7.14 - Replacing a Stairarm
1.
Remove the left and right side rear cover.
2.
Remove the cover from the rear of the stairarm. The cover’s retaining screw is on the inside
and must be accessed from the opposite side of the EFX. Carefully, rotate the stairarm to a
position just forward of vertical to gain access to the cover’s retaining screw.
3.
Remove the lift cover per Procedure 7.2.
4.
Grasp the center ramp cover and lift it upwards to unsnap it from the ramp. Remove the
center ramp cover from the EFX and set it aside.
5.
Remove the two screws that fasten the ramp end cap to the ramp. Remove the ramp end
cap. Refer to Diagram 7.11.
6.
The left side and/or right side ramp trim will need to be removed in order to access the
stairarm wheels.
7.
Loosen, but do not remove, the five screws that fasten ramp trim(s) required to access the
wheel(s) being replaced. Slide the ramp trim(s) off the front of the ramp.
8.
Remove the plastic cap from the stairarm connector. Remove the bolt that fastens the
stairarm connector to the stairarm. Retain the bolt, two washers, a steel spacer and a large
black spacer for later use. Refer to Diagram 7.14.
Diagram 7.14 - Stairarm and Stairarm Connector
Mounting
Bolt
Stairarm
Connector
Plastic
Cap
Retaining
Ring
Stairarm
