Model PD6262 Analog Dual-Input Rate/Totalizer Instruction Manual
47
Setting the Display Parameters & Intensity (
dsplay
)
The upper display (
Big
) can be programmed to display:
1. Ch-A rate (
D Ch-A
)
2. Ch-B rate (
D Ch-B
)
3. Ch-C math channel (
D Ch-C
)
4. Toggle Ch-A & Ch-B rate (
D AB
)
5. Toggle Ch-A rate and Ch-C (
D AC
)
6. Toggle Ch-B rate and Ch-C (
D BC
)
7. Toggle Ch-A & Ch-B rate, and Ch-C (
D ABC
)
8. Ch-A total (
D T-A
)
9. Ch-B total (
D T-B
)
10. Ch-A grand total (
D GT-A
)
11. Ch-B grand total (
D GT-B
)
12. Toggle Ch-A rate and total (
D RT-A
)
13. Toggle Ch-B rate and total (
D RT-B
)
14. Toggle Ch-A rate and grand total (
DRGT-A
)
15. Toggle Ch-B rate and grand total (
DRGT-B
)s
16. Relay set points (1-8) (
DSET 1
to
DSET 8
)
17. Max, min, and max & min values for
Ch-A, Ch-B, or Ch-C (
D Hi-A
to
d HL-C
)
18. Toggle Ch-A rate & units (
d A-u
)
19. Toggle Ch-B rate & units (
d B-u
)
20. Toggle Ch-C & units (
d C-u
)
21. Toggle Ch-A total & units (
d TA-u
)
22. Toggle Ch-B total & units (
d TB-u
)
23. Toggle Ch-A total and Ch-B total (
d tAb
)
24. Toggle Ch-A total, Ch-B total, and the sum of total A and
total B (
d tABC
).
Notes: The sum of total A and B for t ABC is independent of channel C
programming. Channel C may be used normally by a different display
selection even when
D tABC
is selected for one of the two displays.
25. Modbus input (
nm bus
)
The lower display (
Little
) can be programmed to display:
1. All options for the upper display
2. Off, with no display (
d ofF
)
3. Engineering units for any single channel, total, or grand total
