background image

2

3

IMPORTANT SAFETY INSTRUCTIONS

Recommendation:

For the installation of the equipment, it is 

important that the PPA specialized installer 

follow all the instructions mentioned in 

this TECHNICAL MANUAL and in the USER 

MANUAL.

Equipped with the USER MANUAL, the 

installer must present all the information, 

uses and safety items of the equipment to 

the user.

Before using the operator, read and strictly 

follow all instructions contained in this 

manual.

-Before installing the operator, make 

sure that the local electrical network is 

compatible with that required on the 

equipment identification label;

-Do not turn on the mains until the 

installation / maintenance is completed. 

Make the electrical connections of the 

command board always with the power 

grid turned off;

-After installation, make sure that the gate 

parts do not extend over the streets and the 

public footpath;

-The use of total shutdown devices is 

mandatory when installing the operator;

-This product is only suitable for vertical 

parts with balanced drive.

INDEX

IMPORTANT SAFETY INSTRUCTIONS ........................................................................................ 3

TECHNICAL CHARACTERISTICS .................................................................................................. 4

TOOLS REQUIRED FOR INSTALLATION  .................................................................................... 6

ELECTRICAL INSTALLATION   ....................................................................................................... 6

CARE WITH THE ELECTRICAL INSTALLATION  ........................................................................ 7

GATE CARE BEFORE OPERATION   .............................................................................................. 8

INSTALLATION AND FIXING OF THE OPERATOR  .................................................................. 9

ANALOG LIMIT SWICH INSTALLATION  ..................................................................................14

MAINTENANCE ...............................................................................................................................17

Summary of Contents for DZ RIO










Reviews: