Chapter 1 Unpacking Check and Model Explanation
ADSD-S-S
11
1-3 Parts of the servo controller name
CN1
CN2
L1
L2
R
S
TUV
W
RB
RB1
E
Main power lamp
Heatsink socket
Fasten the control and for
heat dissipation
Numerical display, display
monitor value,parameter
values, parameter values
Run lamp
Controller connector
Consistent with
programmable controller
or control
I
/
O
Encoder connector
Consistent with servo encoder
Control circuit input terminals
L1 and L2 offer 1-phase 220V
50/60Hz VAC supply.
Main circuit output terminals
Ensure the voltage class of supply
power consistent with the rated
voltage of servo drive, if the
voltage class of supply power out of
range will damage the control.
Internal and external braking
resistance connected terminals .
Note：if internal braking resistance
can't meet the demand, parallel in
the terminals of RB and RB1 with
corresponding resistance .
Down key
Up key
Ground terminal
Exit key
Confirmed key
Operating space
Main circuit input terminals
R,S,T offer 220V 50/60Hz
VAC supply.
C
hapter 2 Installation
ADSD-S-S
12
Chapter 2 Installation
2-1 Safety and precautions
Please pay close attention to the following installation notes:
1
）
The personnel without qualified training, who works at servo driver devices/system or not abides
by relevant provisions of the "warning",
may cause
serious personal injury and
property damage .
Only the person who was trained and was qualified after the authenticated about the equipment, such
as the design, installation, commissioning and operating, could be allowed to operate the equipment.
2) Do not bend or strain the connection cables between servo drive and motor.
3) When mounting servo drive, make sure to tighten screws to secure the drive in place.
4) If the servo motor shaft is coupled directly to a rotating device ensure that the alignment
specifications of the servo motor, coupling, and device are followed.
5) If the length of cable connected between servo drive and motor is more than 20m, please increase
the wire gauge of the encoder cable and motor connection cable (connected to U, V, W
terminals).
6) Make sure to tighten the screws for securing motor.
2-2 Storage conditions
The product should be kept in the shipping carton before installation. In order to retain the
warranty coverage, the servo drive should be stored properly when it is not to be used for an
extended period of time. Some storage suggestions are:
●
Store in a clean and dry location free from direct sunlight.
●
Store within an ambient temperature range of -20°C to +65°C.
●
Store within a relative humidity range of 0% to 90% and non-condensing.
●
Do not store in a place subjected to corrosive gases and liquids.
●
Correctly packaged and placed on
shelf or
table.
2-3 Installation conditions
The ambient temperature of servo drive for long-term reliability should be within under
0 ~55 .
℃
℃
If the ambient temperature of servo drive is greater than 45°C, please install the drive in a
well-ventilated location and do not obstruct the airflow for the cooling fan. The servo drive and
motor will generate heat. If they are installed in a control panel, please ensure sufficient space
around the units for heat dissipation. Pay particular attention to vibration of the units and check if the
vibration has impacted the electric devices in the control panel. What’s more, please observe the
following precautions when selecting a mounting location:
●
The location without heat-radiating elements or high temperature;
●
The location without dropping water, steam, dust or oil.
●
The location without inflammable or combustible or explosive gas or liquid;
●
The location without airborne dust or metallic particles.
