PowerBoozt LfeLi-48100TB, User Manual

Page: 95 / 192

V1.01
95
FAQ
Can I continue to use my current charger?
That depends on which charger is installed.
If the charger has a setting for GEL or AGM batteries, it can usually be
used.
However, the final charge voltage should not exceed 14.6 V.
Characteristics for lead-acid batteries with liquid electrolyte should not be
used.
Ideally, the charger should have an IU characteristic for LiFePO4 batteries.
Which LiFePO4 battery do I need to replace my two heavy AGM batteries of 95 Ah each?
If the previous capacity was sufficient, two 95Ah AGM or Gel batteries can be used
replaced by one 100Ah PowerBoozt battery.
Should the lithium battery be left on the charger permanently during winter?
That is not necessary, on the contrary.
Fully charge the battery to approx. 60-80% and then disconnect or disconnect the battery from
the vehicle.
In my vehicle it sometimes gets to 50°C and more in the summer. Will it damage my lithium battery?
The operation of the PowerBoozt lithium batteries is possible up to 60°C without any problems.
And what about sub-zero temperatures??
Discharging to -20°C is also possible here, but charging below 0°C must be recharged
limited or prevented.
This can be done with a charge booster and/or a temperature controlled charger.
Will the PowerBoozt batteries fit into the installation space where my previous batteries were
installed?
If 92-95Ah AGM batteries or 80Ah GEL batteries are installed, the PowerBoozt
Lithium too, it has the same dimensions and mountings.
In the VW Bus the 90Ah fits under the seat, in the Ducato the 100Ah.
Should the lithium battery always or regularly be fully discharged?