PowerBoozt LfeLi-48100TB, User Manual

Page: 109 / 192

V1.01
109
POWER ON / RESET
The reset button acts as an on switch (dual function).
To turn on the unit - press and hold the RST button for 3 seconds.
To turn off the unit, press and hold the RST button for 3 seconds.
The reset function is reached when the unit is turned on and by pressing the RST button 6
hold for seconds and release.
DRY CONTACT (potential-free contact)
The function of the potential free contact is to provide an interface for the status of the
remote monitoring battery.
Failure alarm indicates BMS or battery failure, including but not limited to charging and
discharge MOS failure, cell voltage below 0.5V, NTC shutdown.
Protection alarm: Output short circuit, charge and discharge over current, charge and discharge
over/low temperature.
OUTPUT (exit)
A total of 4 output terminals, 2 positive and 2 negative marked P+ & P-.
Each clamp has the specification for M8 Stud. Required Torque Settings: 6.1N-7.5N.
MCB (Mini Circuit Breaker)
Protects circuits against short-circuit and overload currents.
LCD screen
LCD display shows Battery status, cell status, firmware version, security/alarm, etc.
MENU OPERATING INSTRUCTIONS
The LCD display interface is user-friendly as shown in the figure below.
It provides a 320*240 dot matrix graphic display.
The LCD can display the alarm information in real time and display the history of the
alert records for the user to request and provides a reliable basis for a
any faulty battery diagnosis condition.
Users can easily browse the battery parameters through the LCD interface and access
get to information about the current condition of the battery. The interface has a total of 5