PowerBoozt LfeLi-48100TB, User Manual

Page: 58 / 192

V1.01
58
Settings
Parallel in mono-phase – PB.UPS.10.10.48 – PB.UPS.15.15.48
STEP 1: Check the following requirements before commissioning:
- Correct wire connection
- Make sure all circuit breakers in the load side cabling are open andthat all neutrals of all units
are connected to each other.
STEP 2: On the bottom panel of the inverter, there are 5 pin DIP switches, you can set it as
follows in the figure below
REMARK 1 : If there are two inverters in parallel, you only need to set inverter (1) and inverter (2)
Set
REMARK 2: It is necessary to switch off the consumers when using the DIP switches Set, otherwise the
setting cannot be programmed.
STEP 3: turn on any inverter.
LCD screen on “MASTER” inverter LCD screen on “SLAVE” inverter