V4.0
200A Multi-Process Welder with LCD Display
8785115
Visit www.princessauto.com for more information
43
CARE & MAINTENANCE
1. Maintain the tool with care. A tool in good condition is efficient, easier to
control and will have fewer problems.
2. Inspect the tool fittings, alignment, hoses and power supply cord periodically.
Have damaged or worn components repaired or replaced by an authorized
technician. Only use identical replacement parts when servicing.
3. Exposure to extremely dusty, damp, or corrosive air is damaging to the
welding unit. In order to` prevent possible failure or fault of this welding
equipment, clean the dust at regular intervals with clean and dry
compressed air.
4. Follow instructions for lubricating and changing accessories.
5. Only use accessories intended for use with this tool.
6. Keep the tool handles clean, dry and free from oil/grease at all times.
7. Maintain the tool’s labels and name plates. These carry important
information. If unreadable or missing, contact Princess Auto Ltd. for
replacements.
WARNING! Only qualified service personnel should repair the tool. An
improperly repaired tool may present a hazard to the user and/or others.
MIG TORCH LINER INSTALLATION
1. Lay the torch out straight on the ground and remove the front-end parts.
2. Remove the liner retaining nut.
3. Carefully pull the liner out of the torch cable assembly.
4. Select the correct new liner and carefully unravel, avoiding putting any
kinks in the liner, if you kink the liner it will require replacement.
5. Carefully and slowly feed the liner in short forward movements down the
cable assembly all the way through and out the torch neck end. Avoid
kinking the liner. A kinked liner must be discarded and replaced.
6. Fit the liner retaining nut and screw down only half way.
7. Snip the liner approximately 1/8 in. (3 mm) past the end of the torch neck.
8. Place the tip holder over the end of the liner and screw into the torch neck
trimming it up tight.
