5-77
PFC-6800 • 5403602 • Rev B • 2/13
In the
3.
“Subject” field
, enter one or more of the following keywords:
History
•
to
send a current event history report back to sender.
Status
•
to send a current detector (sensitivity) status report back to sender.
Configuration
•
to send a current configuration file back to sender.
Unsubscribe
•
to stop the current e-mail settings for the sender until panel is reset or that e-mail address sends a
“
Subscribe
” to the panel.
Subscribe
•
to activate e-mail settings for the sender.
Note
: Keywords are NOT case sensitive and more than one can be entered in the subject line of the e-mail.
There are no restrictions on contents entered into the body of the e-mail.
4.
Important Reminders!
The person sending the e-mail
•
must
be added to the e-mail list in the
“E-mail Reporting” section
of the software as
shown below. If the sender is not in the list, the panel will not respond.
The
•
“Enable E-mail Requests”
option must also be checked for the sender to receive e-mails when requested from the
panel or a remote PC.
E-mail Reporting Window
Figure 102.
System e-mail communications and functions are intended for informational reporting purposes only. They are intended to be used as a
convenience function. e-mail communications should NOT be used as a primary means of reporting emergency information.
Note
: You may choose not to select
specific event types or reports for
e-mail addressees.
If so, choose
Browse List
from
the
Data Transfer
panel menu
option. Then scroll through e-mail
addresses and select one or more
recipients.
Sender's e-mail must be in the
e-mail list and
the Enable E-mail
Requests box must be checked
.
