3-41
PFC-6800 • 5403602 • Rev B • 2/13
Setting Addresses
The FIB-1000's address is set by
dip switch S1
, which is located on the back of the board. The address must be set in the range
of one to thirty (1–30) to be recognized by the panel.
(Refer to the "P-Link Addresses" table shown earlier in this section for DIP
switch programming.)
FIB-1000 Back Panel Showing Dip Switch Location
Figure 49.
Serial Parallel Gateway Installation (SPG-1000)
An optional SPG-1000 serial/parallel gateway (printer drive) board can be mounted inside the Ae-8 or Ae-14 accessory
enclosure, or the SPG-1000RM rack mount enclosure. The SPG-1000RM includes a standard 19 inch rack-mount enclosure,
which can then be installed directly in an equipment rack. Up to thirty-one (31) printers may be installed on this panel.
SPG-1000 Serial Parallel Gateway Board & Rack Mount
Figure 50.
SPG-1000 Wiring to Control Panel Example
Figure 51.
DWG #608-24
Dip Switches
P-Link
Connections
S1
DWG #608-16
DWG #608-15
DWG #608-26
P-Link
-
+ A B
P-Link from
control panel
Example:
Powered by
control panel
