PosiPin 5
FEEDBACK
Depending on the programming mode chosen, the feedback will differ. In
the section
System Programming
on page 6 and
Master Programming
on
page 11, the combinations of visual feedback and beep tones are specified
step by step.
Visual Feedback
: When information is entered on the reader’s keypad, the
red and/or green LEDs will flash, remain constant or extinguish depending
on the step reached in programming.
Confirmation Beep
: When an operation is successfully entered, the
reader emits a rapid series of beep tones (“beep-beep-beep-beep-beep”).
Rejection Beep
: When the system reverts to a previous status or an
operation is incorrectly entered, the reader emits one long beep tone
(“beeeeeeeeeep”).
RESETTING TO DEFAULT
To reset all sections to factory defaults, disconnect reader’s power supply.
Press and hold the
[1]
and
[2]
keys simultaneously while re-connecting its
power supply. Sections are reset when the reader emits a confirmation
beep.
CARD PRESENTATION TEST
Place the card parallel to the PosiPin reader (as
shown in the figure) and move it toward the
reader until the reader provides audio or visual
feedback.
