12 Installation and Operating Instructions
each digit can be any value from 0 to 9. You can use the table on page 17
to record the User Codes.
When you press the
[
CLEAR
]
key in step 5:
If the section is not programmed, PosiPin will exit the section and
revert to step 4. If a card was entered or a key was pressed, PosiPin
will delete the information and remain in the section. You can then
enter a new card or PIN.
To program User Codes:
1. Press and hold the
[
CLEAR
]
key for 4 seconds.
The reader emits a confirmation beep, the green LED illuminates and
the red LED extinguishes.
2. Enter
[
MASTER
CODE
1
or
MASTER
CODE
2]
and press the
[
ENTER
]
key.
Reader emits a confirmation beep and the red and the green LEDs
flash simultaneously.
3. Enter
[203]
and press the
[
ENTER
]
key.
Reader emits a confirmation beep and the red and the green LEDs
flash alternately.
4. Enter the User Code number from
000
to
999
. Press the
[
ENTER
]
key.
The reader emits a confirmation beep and the green LED illuminates.
If the red LED illuminates, the section is empty. If the red LED stays
extinguished, a User Code is already programmed in the section.
5. Program the card and/or code depending on the Card/Code Option
selected (see page 6). If Reader Only or Keypad Only are enabled,
present the card to the reader or enter the PIN. If Keypad and Reader
are enabled, first present the card to the reader and then enter the
PIN. Press the
[
ENTER
]
key.
The reader emits a confirmation beep and advances to the next
section.
6.
To program another section, repeat step 5
. To exit, press and hold
the
[
CLEAR
]
key for 4 seconds.
