BIOS Setup Information
ROBO-638 User’s Manual
4-23
Code Description
99
Any initialization required after the option ROM test has completed.
Configuring the timer data area and printer base address next.
9A
Return after setting timer and printer base address. Going to set the RS-232
base address.
9B
Returned after setting the RS-232 base address. Performing any required
initialization before the Coprocessor test next.
9C
Required initialization before the Coprocessor test is over. Initializing the
Coprocessor next.
9D
Coprocessor initialized. Going to do any initialization after Coprocessor test.
9E
Initialization after the Coprocessor test is complete. Checking the extended
keyboard, keyboard ID, and Num Lock key next. Issuing the keyboard ID
command next.
A2
Displaying any soft errors next.
A3
Soft error display complete. Going to set keyboard typematic rate.
A4
Keyboard typematic rate set. To program memory wait states.
A5
Memory wait state programming is over. Clearing the screen and enabling
parity and the NMI next.
A7
NMI and parity enabled. Performing any initialization required before
passing control to the adaptor ROM at E000 next.
A8
Initialization before passing control to the adaptor ROM at E000h completed.
Passing control to the adaptor ROM at E000h next.
A9
Returned from adaptor ROM at E000h control. Performing any initialization
required after the E000 option ROM had control next.
AA
Initialization after E000 option ROM control has completed. Displaying the
system configuration next.
AB
Building the multiprocessor table, if necessary.
AC
Uncompressing the DMI data and initializing DMI POST next.
B0
The system configuration is displayed.
B1
Copying any code to specific areas.
00
Code copying to specific areas is done. Passing control to INT 19 h boot
loader next.
4.12 Flash BIOS Utility
Utilize AMI Flash BIOS programming utility to update on-board BIOS for the
future new BIOS version. Please contact your technical window to get this utility
if necessary.
NOTE : Remark or delete any installed Memory Management Utility (such as
HIMEM.SYS, EMM386.EXE, QEMM.EXE, …, etc.) in the
CONFIG.SYS files before running Flash programming utility.
