BIOS Setup Information
ROBO-638 User’s Manual
4-22
Code Description
54
Shutdown was successful. The CPU is in real mode. Disabling the Gate A20
line, parity, and the NMI next.
57
The A20 address line, parity, and the NMI are disabled. Adjusting the
memory size depending on relocation and shadowing next.
58
The memory size was adjusted for relocation and shadowing. Clearing the
Hit <DEL>
message next.
59
The
Hit <DEL>
message is cleared. The
<WAIT…>
message is displayed.
Staring the DMA and interrupt controller test next.
60
The DMA page register test passed. To do DMA#1 base register test.
62
DMA#1 base register test passed. To do DMA#2 base register test.
65
DMA#2 base register test passed. To program DMA unit 1 and 2.
66
DMA unit 1 and 2 programming over. To initialize 8259 interrupt controller.
7F
Extended NMI sources enabling is in progress.
80
The keyboard test has started. Clearing the output buffer and checking for
stuck keys. Issuing the keyboard reset command next.
81
A keyboard reset error or stuck key was found. Issuing the keyboard
Controller interface test command next.
82
The keyboard controller interface test completed. Writing the command byte
and initializing the circular buffer next.
83
Command byte written, Global data init done. To check for lock-key.
84
Locked key checking is over. Checking for a memory size mismatch with
CMOS RAM data next.
85
The memory size check is done. Displaying a soft error and checking for a
password or bypassing Setup next.
86
Password checked. About to do programming before setup.
87
The programming before Setup has completed. Uncompressing the Setup
code and executing the AMIBIOS Setup utility next.
88
Returned from CMOS setup program and screen is cleared. About to do
programming after setup.
89
The programming after Setup has completed. Displaying the power on
Screen message next.
8B
The first screen message has been displayed. The <WAIT…> message is
displayed. Performaing the PS/2 mouse check and extended BIOS data
area allocation check next.
8C
Programming the Setup options next.
8D
Going for hard disk controller reset.
8F
Hard disk controller reset done. Floppy setup to be done next.
91
The floppy drive controller has been configured. Configuring the hard disk
drive controller next.
95
Initializing the bus option ROMs from C800 next.
96
Initializing before passing control to the adaptor ROM at C800.
97
Initialization before the C800 adaptor ROM gains control has completed.
The adaptor ROM check is next.
98
The adaptor ROM had control and has now returned control to BIOS POST.
Performing any required processing after the option ROM returned control.
