System Installation
ROBO-638 User’s Manual
3-3
NOTE : For maintaining system stability, don’t change any of DRAM
parameters in BIOS setup to upgrade your system performance
without acquiring technical information.
3-3 Installing the Single Board Computer
To install your ROBO-638 into standard chassis or proprietary environment,
you need to perform the following :
□
Step 1 : Check all jumpers setting on proper position
□
Step 2 : Install and configure CPU and memory module on right position
□
Step 3 : Place ROBO-638 into the dedicated position in your system
□
Step 4 : Attach cables to existing peripheral devices and secure it
WARNING
Please ensure that your SBC properly inserted and fixed by
mechanism. Otherwise, the system might be unstable or do not
work from bad contact of golden finger.
3-3-1 AIC-7890 Ultra-2 SCSI Host Adapter
The following table will show you how to enable and disable on-board
Fast/Ultra and Ultra-2 SCSI function by putting jumper on the proper position
of ROBO-638. ROBO-638Z does not support this feature.
JP3 FUNCTION
NC
Enable on-board SCSI
Short
Disable on-board SCSI
NOTICE
Please notice that on-board PCI Ultra-2 SCSI device occupies
REQ3# and GNT3# signals. If on-board PCI SCSI interface is
enabled, the PCI slot#4 only allows Non-Bus-Master PCI
device card.
