Porter & Charles STPS60TM-1, Instructions For Use Manual, Page: 9 / 76

9
Basic settings
Initial Settings
After your steam oven is first connected in or after
a power failure, the clock display will flash to
indicate that the time shown is not correct.
The oven will not operate until the clock and the
water hardness parameter is set.
The default setting for water hardness is typically
Medium. This can be adjusted based on the water
hardness in your area. This can be confirmed with
your municipality.
To set the clock and the water hardness parameter
value proceed as described in the following
chapters:
Setting the clock
Before using the oven, adjust the clock through the procedure described below but starting on Step 3. To
set the clock, proceed as follows:
1.
Press the “+” key until the
Clock Indicator
Light starts to flash.
2. Press the OK key.
3. Press the
“+”
and
“-“
keys to set the correct
hour value.
4. Press the OK key to validate the hour value.
The minute numbers will start to flash.
5. Press the
“+”
and
“-“
keys to set the correct
minute value.
6. To finish, press the OK key again.
Hiding / Displaying the Clock
If the clock display disturbs you, you can hide it by proceeding as follows:
1.
To block, the oven press the “
+
” key and the
“
-
“ key simultaneously for 5 seconds. The
dots that separate the hours and minutes and
the clock symbol will flash, but the rest of the
clock display will be hidden.
2. If you want to see the clock display again,
press the
“
+
” and “
-
“ keys again for 5
seconds.