Polyaire airtouch, Installer Manual

Page: 12 / 68

12
4.10 Replace the side covers back on the main
control and extension module once finished setting
and commissioning.
4.11 Remove the cover of the ITC from the base. Install the base with screws in
proper positions where there is no direct sun, no draft and about 1.5m above
ground. Set the correct group number and identification number (Sub ID) for
each sensor. And activate the battery to start the wireless sensor. Then align the
cover with the base and click the cover to position to complete the sensor
installation.
4.12 Fit the Console to wall
The plastic casing of the console consists of two halves. The front cover
contains the PCB board along with the LCD/console. The back cover
attaches to the wall as a mounting base. During the installation process the case
will have to be opened to mount the console on the wall. Follow the steps below
to carefully install the console to the wall:
a. Slide the back base to bottom side to clear the stops on the front cover
b. Remove the base from the front cover
c. Position the back base on the wall where the cable is (about 1.5m high from
the floor). Ensure it is away from any heat or cool source and mark the cable
hole and screw holes.
Note: The correct back cover direction is marked on its surface; follow that
mark when fixing the back cover.
Component Installation
Continued on next page