POLTI Vaporetto MV 20.20, Instruction Manual

Page: 39 / 120

E
N
G
L
IS
H
| 39 |
You can activate the suction function either
by using the ON push-button (U) on the
control panel or by the suction push-button
on the handle.
From the control panel: Press the ON push-
button (U) and hold it down for a few
seconds. The suction fan will start to run at
the lowest speed, and the first level of the
suction UP indicators will stop flashing and
remain steadily lit. See paragraph 5.1 for
suction adjustment.
From the handle: press the push-button on
the handle. The suction fan will start to run at
the lowest speed, and the first level of the
indicators will stop flashing and remain
steadily lit
.
See paragraph 5.2 for suction
adjustment.
2.3 DETERGENT FUNCTION
It is possible to use this function with: the
Steam & Vacuuming Kit PAEU0375 (chap.
9.1), the Vaporflexi Brush Steam Kit
PAEU0377 (chap. 9.2), the Steam Mop
accessory PAEU0257 (chap. 9.15).
To use the washing function, dispensing
water:
• Press the main switch (Z) located under the
control panel, the first level of the suction
indicators (T) will begin flashing.
• Press the boiler on button (W). The boiler
indicator light will come on (S).
• Press the detergent switch (B).
The function indicator will turn orange.
In this way, by pressing the steam button
on the handle, a jet of detergent mixed
with steam is released. Set the steam
regulator to the lowest level.
• To stop the function, press switch (B)
again.
2.4 COMBINED FUNCTIONS
It is possible to combine the following func-
tions:
STEAM – VACUUMING
STEAM – DETERGENT
These functions are possible with: the Steam
& Vacuuming Kit PAEU0375 (chap. 9.1), the
Vaporflexi Brush Steam Kit PAEU0377 (chap.
9.2), the Steam Mop accessory
PAEU0257(chap. 9.15).
3. CONNECTION KIT AND
OPTIONAL ACCESSORIES
All the accessories can be connected directly
to the flexible steam/vacuum hose (1; 9) or to
the extension hoses (2; 10).
3.1 Hook the two extension tubes onto the
handle :
Move the locknut of the
accessory, if present, to
the OPEN position and
connect the accessories.
Move the accessory
locknut to the CLOSED
position.
Check the strength of the
connection.
There is another lock
button on the extension
tubes:
proceed as above for the
accessories, releasing the tubes by sliding the
button as far as the lock position.
3.2 To use the other accessories proceed as
follows:
- Move the locknut to the OPEN position and
pair the accessories.
- Move the accessory locknut to the CLOSED
position.
Check the strength of the connection.
3.3 To connect the special accessories only
for vacuuming it is only necessary to pair
them.
3.4 To connect the steam lance to the steam
concentrator, screw it on. The same
operation can be carried out for the coloured
brushes, which can be screwed both onto the
steam concentrator and onto the steam
lance. The different colours enable a
diversified use of the brushes according to
the surface to be treated.
WARNING: On the first release of steam,
there may be some drops of water mixed
with the steam due to temperature imbal-
ances.
Direct the first jet of steam onto a rag.
To avoid any dirt in the dirt collector causing
bad smells, we recommend emptying and
cleaning after every use according to the
methods described in Chapter 12.
WARNING: Suction function should be used
to pick up liquids/wet substances only, not
for collecting dry dirt.