Polaris Timbersled ST 93 RIPPER 2019, Owner'S Manual

Page: 66 / 84

6. Using the composite fork clamp
a
(fork clamp halves are identical), place
one half of the fork clamp in front of the fork tubes
A
with the concave
portions sitting around the face of the lower fork tube. Take the other half and
mate it around the back side of the fork tubes between the fork tubes and the
spindle backer plate. Take the Fork Clamp washer plate
s
and place it over
the face of the front fork clamp lining up the bolt holes of the washer plate
with the clamp.
Using Qty.–2, M8 x 75mm bolts
i
supplied with your kit, insert bolt through
the washer plate, both halves of the fork clamp, and through the spindle
backer plate. Apply the supplied M8 locking nuts
o
and torque to
specification listed below.
TORQUE
20 Nm (15 Ft. Lbs)
7. Tighten front axle bolt
B
.
IMPORTANT
Refer to manufacturers specifications for proper torque setting.
8. Check to ensure all previous steps are complete then move on to the rear
cowling assembly section.
64
INSTALLATION