Polaris Timbersled ST 93 RIPPER 2019, Owner'S Manual

Page: 37 / 84

I - INSPECT (CLEAN, ADJUST, TIGHTEN, LUBRICATE, REPLACE IF NECESSARY)
C - CLEAN, R - REPLACE, L - LUBRICATE
ITEM
FREQUENCY
150
MI.
(240
KM)
500
MI.
(800
KM)
1000
MI.
(1600
KM)
2000
MI.
(3200
KM)
PRE-
SEASON
Idler Bolt Jam Nut
I I I I
Track Alignment
I I I I I
Track Tension
I I I I I
Fork Clamp Bolts
I I I I
Swing Arm Bolts
I I I
Strut Rod Bolt
I I I I
Front Axle Bolt I I I I
LUBRICATION
CHAIN LUBRICATION
Lubricate the chains every 8 to 10 hours of operation. We have found that the
use of Maxima Chain Wax for O- ring chains works best. It is recommended to
lift the track off the ground. Start the bike and put it into first gear and let the
clutch out allowing the drive system to spin. Slowly spray lube directly onto the
chain rollers and O-rings, soaking the chain. This will allow good penetration into
the moving chain parts.
EXHAUST SYSTEM
For exhaust system inspection procedures, see your host bike’s owner’s
manual.
CAUTION
Hot exhaust system parts can cause burns. Allow adequate time for the
exhaust system to cool. Never perform this procedure with the engine running.
35
MAINTENANCE