Polaris Timbersled ST 93 RIPPER 2019, Owner'S Manual

Page: 32 / 84

WARNING
Use of traction products such as studs, ice growsers, etc. will increase the
possibility of track damage and/or failure. This could cause loss of control,
resulting in serious injury or death. Always inspect for track damage before
operating the snow bike.
Follow these steps to ensure proper warm-up of the engine, drive train and
track.
1. Use an appropriate stand to securely support the rear of the snow bike at the
rear bumper. The track should be about 4 inches (10 cm) off the ground.
2. Start the engine and allow it to warm up two to three minutes.
3. Engage the throttle abruptly and allow the track to rotate several revolutions.
TIP
It will take longer to warm up the track sufficiently during colder outdoor
temperatures.
4. Release the throttle, apply the brakes, shut off the engine and lower the
snow bike to the ground.
5. Grasp the ski by the front loop and move it from side to side to loosen snow
and ice.
30
OPERATION