Polaris Timbersled ST 93 RIPPER 2019, Owner'S Manual

Page: 52 / 84

INSTALLATION INSTRUCTIONS
MOTORCYCLE DISASSEMBLY:
NOTE
The disassembly process listed is universal for all bikes using the ST 93 Ripper
kit. This process may vary slightly between makes and models. Refer to your
host bike’s owner’s manual for specific references and disassembly
procedures.
1. Place bike on a stand or suitable support where both wheels are off the
ground. Secure properly to prevent bike from tipping when wheels are
removed.(An adjustable stand is helpful for reassembly.)
2. Remove the seat and side panels.
3. Remove chain by disconnecting master link.
4. Remove the rear brake lever from frame and let hang (this includes the
spring).
5. Remove upper rear shock bolt or pin.
NOTE
Keep upper shock bolt for later use as this item will be reinstalled.
6. Remove the rear swing arm bolt (this will drop the entire swing arm assembly
off the bike) and remove the shock, tire, brake, and swing arm assembly from
the bike as a complete unit.
NOTE
It is recommended to cable tie all bushings, spacers, etc. to their
corresponding parts at all pivoting points to prevent losing any parts during
storage.
7. Remove the front brake lever and cable retainer bolts from the bikes front
forks. (On some models use the provided cable tie to secure start button).
8. Loosen the front axle bolt and remove the front wheel.
NOTE
Keep front axle bolt for later use, this item will be reinstalled.
9. Remove the front drive sprocket and sprocket cover.
50
INSTALLATION