Polaris Timbersled ST 93 RIPPER 2019, Owner'S Manual

Page: 62 / 84

DRIVE CHAIN AND SPROCKET ASSEMBLY
1. Install provided sprocket
w
and bearing carrier housing
e
onto transmission
output shaft. Make sure to use Blue Loctite ® 243 on the provided 3 button
head screws
y
. HONDA ONLY: Place provided spacer
q
onto output shaft
before installing sprocket.
NOTE
Reference you host bikes owner’s manual or manufacturers specifications for
proper torque specifications.
2. Tighten sprocket backer plate
e
to the engine case and torque to bike
manufacturers specifications before chain
u
is installed and chain tension is
set.
3. Route chain
u
around both sprockets.
4. Complete the assembly of the chain with the master link provided. Be sure to
install the master link with the opening of the link facing rearward in relation
to the chain direction.
5. Set the proper chain tension by loosening chain slider nut and bolt. Slide the
chain slider up or down until 1/2”-5/8” of vertical deflection is met in the upper
chord of the drive chain. Torque chain slider nut to specification below when
proper tension is achieved.
60
INSTALLATION