2.56
9850067 R01 - 2020-2021
GENERAL
/
GENERAL XP
Service Manual
© Copyright Polaris Inc.
BATTERY INSTALLATION (INTL)
NOTICE
Using a new battery that has not been fully charged can
damage the battery and result in a shorter life. It can
also hinder vehicle performance. Refer to
“Battery
Charging” page
procedure before installing the
battery.
1. Place the battery in the battery holder and secure
with hold-down strap. Torque fastener to
specification.
TORQUE
Battery Bracket:
3.5 lb-ft (5 Nm)
2. Coat the terminals with dielectric grease.
3. Connect and tighten the red (+)
q
cable first.
4. Connect and tighten the black (-)
w
cable last.
5. Verify that cables are properly routed and reinstall the
driver’s seat.
ENGINE / CHASSIS ELECTRICAL
GROUND
Inspect the ground cable connections. Remove ground
terminals and clean if necessary.
1. The chassis ground connection
w
, located below the
start solenoid
q
, can be accessed through the left
rear wheel area.
2. Inspect the chassis ground terminals. Be sure the
grounds are clean and tight.
