Polaris 2012 Sportsman Forest 500 International, Service Manual

Page: 373 / 432

10.9
ELECTRICAL
10
9923412 - 2012 Sportsman 400/500 and EFI Tractor Service Manual
© Copyright 2011 Polaris Sales Inc.
Setting A New Service Interval
1. While in the service interval mode, press and hold the
mode/override button until the wrench icon flashes.
When it begins to flash, release the button.
2. The setting will increase by one hour each time the
button is pressed. Pressing and holding the button will
allow the numbers to escalate much faster.
3. When the desired time increment is displayed,
release the button and wait for the wrench to stop
flashing. When the wrench stops blinking, your
service hours are set.
NOTE: If you scroll past the intended number, hold
the button down until the count turns over to 0. You
can then reset the number.
Turn Service Interval OFF:
1. If the service interval is enabled (functioning) on your
ATV and you wish to turn it off, toggle to the service
interval mode.
2. Press and hold the mode button for approximately 7
seconds until the word OFF appears in the Rider
Information Center. The service interval is now
OFF.To enable (turn on) the service interval mode,
repeat the steps above in “Setting Service Interval
After Countdown”.
Change Service Interval Time:
If you would like to change the service interval time, (for
example change the interval from 50 hrs. to 55 hrs.).
Follow the steps below:
1. While in the service interval mode, press and hold the
mode button for approximately 7 seconds until the
word OFF appears in the Rider Information Center.
2. Wait 5 seconds and then press the mode button in
until the wrench icon flashes.
3. Press the mode button again to set the desired service
increment.
4. Release the button and wait for the wrench icon to
stop flashing. The new service interval is now set.
Screen 6: Miles/Kilometers :
The display in the trip meter and odometer can be
changed to display either kilometers or miles. The current
display mode will be shown as “KM” or “MP”. To change,
hold in the mode button until the letters flash, then press
and release the button once. When the display stops
flashing, the mode has been set.
MP = Miles
KM = Kilometers