28
29
EN
– Installation and operation guide SIMPLE MOVE 102
EN
– Installation and operation guide SIMPLE MOVE 102
EN
EN
If an obstacle is detected (an abnormal force on the drive unit):
• During opening of the gate:
the gate stops.
• During closing of the gate:
the gate stops and reopens.
2.6 Complete opening and closing of the gate
2.7 Obstacle
detection
The remote controls supplied in the set are not
programmed.
The remote control must be programmed.
See point 5.2
3
WIRING OF ACCESSORIES
3.1 Photocells
(optional)
For safety reasons, carry out these activities only with the power supply disconnected.
It is not possible to wire a second set of photocells in the case of this drive unit.
TX
1 2
1 2 3 5
RX
BUSBUS
33
44
▶
Assembly
A
ſt
er wiring the photocells:
• switch the drive on;
• start the gate opening or closing procedure.
The photocells will be recognised by the
electronic control system once this movement
is complete.
▶
Operation with photocells
If the photocells are blocked when closing the
gate, the gate will stop and reopen.
10 W - 24 V bulb MAXIMUM – The use of a bulb with power greater than 10 W- 24 V can cause the drive
unit to malfunction..
3.2 Orange
light
(optional)
▶
Operation of the orange light
The orange light
fl
ashes while the gate is moving.
You are advised to perform self-learning of the gate track before connecting the accessories
(photocells, orange light, etc.)
