18
19
EN
– Installation and operation guide SIMPLE MOVE 102
EN
– Installation and operation guide SIMPLE MOVE 102
EN
EN
1 ASSEMBLY
1.1 Screw
assembly
1.2 Fixing the Drive
▶
Tools required for assembly (not provided)
17
12
3,5
PZ2
T25
10
▶
The sequence of stages
•
Screw assembly
•
Fixing the Drive
•
Toothed bar assembly
•
Mechanical adjustment
1.
Place the assembly template on the ground
(the template is printed on cardboard) and drill
holes using a drill (Ø 12 mm) suitable for the
ground type.
r
2.
Insert the pins (12x60 S12). Tighten
the double-thread screws (M10x15).
p
1.
Screw in 4 nuts (M10, galvanized
n
)
and put 4 washers (
fl
at, Ø10 5x22x2,
galvanized).
o
2.
Remove the cover from the drive.
a
3.
Place the drive onto
the screws: the
fl
ange
(drive basis) must be at
a maximum height of 25
mm above the ground. The
recommended distance is
between 20 and 25 mm.
4.
A
ſt
er the drive is set at the correct height from
the ground, attach it using washers (
fl
at, Ø10
5x22x2, galvanized)
o
and 4 nuts
(M10, galvanized).
n
5.
Insert the cable grommet
h
that has been drilled
through in the hole provided for the supply cable.
Apply a small amount of grease to the
screws before screwing them into the pins.
Use a spirit level to check if the drive is
positioned correctly.
