- 27 -
GB
1600-GB WARTUNG_377
SERVICE AND REPAIR
Note!
•
Too much oil
leads to the
mower bar over-
heating during
operation.
• Too little oil does
not guarantee
the necessary
lubrication.
Important!
In doing so the cutter bar must be in horizontal position.
- Take out oil filler plug (63) and top up oil "SAE 90" up
to the level screw
1)
.
4. Oil level check
The oil level is correct when the oil comes up to the level
screw
1)
(OIL LEVEL).
1) The oil ller plug (63) is also the level screw (OIL LEVEL)
Cutter bar oil level check
• Under normal operating conditions, oil is to be
replenished annually.
1. Lift one side of the mower bar (X1) and support.
X1 = Distance from ground to upper edge of cutter bar.
NOVACAT
225:
X1 = 180 mm
NOVACAT
265:
X1 = 160 mm
• The side where the oil refill screw is located remains
on the ground.
• Lift the other side of the mower bar about
X1
and
support with a suitable prop.
2. Let mower bar stand in this position for some
15 minutes.
• This time is necessary to allow the oil to gather in
the lower area of the mower bar.
3. Remove oil refill screw (63).
The oil level is measured at the oil refill screw hole.
61-00-19
63
OIL LEVEL
61-00-20
OIL LEVEL
