CIP Training
Plockmatic LCT3500 Large Capacity Tray
Troubleshooting - Fault codes
Fault Codes
LCT-108/208 Too Thin, Tray 3/4
Too Thin is a paper thickness error detection. Too Thin checks if a sheet is too thin when it
passes the optical DSD sensor Q101/201. When the optical DSD sensor sees the lead-ing
paper edge, thickness is measured. A Too Thin condition is generated if the measured
thickness on a sheet is too thin compared to the calibration sheet. The sheet will be held in
subsequent unit.
Actions:
•
Open subsequent unit and remove sheet.
•
See Misfeed Tray 3/4 Actions.
LCT-109/209 Please Set Side Guides in Process Position
This error code is displayed if the SP Sensor cannot see the stack of paper. If the opera-tor
forgets to set side guides properly (inwards, touching the sides of the paper stack), this
fault code will be displayed and the tray will open automatically.
Actions:
•
Move the Side Guides inwards so they touch the sides of the paper stack
LCT-110/210 Overloaded
Actions:
•
Remove the extra paper from the tray
•
Ensure that the sensor is clean
•
Check that there are no obstructions between the sensor and the stack of pa
per. ck of
paper
LCT-300 Misfeed Tray A (LSM)
Misfeed is a paper flow error detection. Misfeed checks if a sheet is moved correctly from
the paper pile to DSD sensor. Time is measured from the start of the drive roller (used to
feed and separate a sheet from the paper pile) until the DSD sensor can see the leading
paper edge. A Misfeed condition is generated if this measured time is too long.
Actions:
•
Ensure that DSD sensors Q501/502 are clean and calibrated properly (see sensor cali-
bration procedure in this section of the manual)
•
Check that there are no obstructions in the paper path
•
Turn off the DSD sensor from the Settings page
NOTE:
For components locations, refer to the
Guide to Components
section.
NOTE:
For components locations, refer to the
Guide to Components
section.
