CIP Training
Plockmatic LCT3500 Large Capacity Tray
Basics
B
A
D
F
E
B
A
B
C
D
Loading Paper
1
1
From the Main Menu, select
Load tray 3
or
Load tray 4
depending on which tray you
intend to open and load. Tray 3 is the upper
tray;
2
2
Lift the Paper Guide lock release levers
[A], move the Paper Guides [B] inwards and
adjust them according to the size of the
paper: see label [C]. If the paper stack is
wider than 260 mm / 10.24” install the
Paper Supports [D];
3
3
Prepare the stack of paper following the procedure described in the
“Job preparation” section;
4
4
If running jobs in “auto mode”, measure the paper curl and insert the value in the UI
(see Section 2 - Paper Curl).
NOTE: always load the vacuum trays with paper
that has negative curl
;
5
5
Place the sheets on the elevated tray bottom [E]. Place the leading edge of the sheets
against the Separation Frame [F], underneath the vacuum belts;
NOTE: if you are loading the trays with thick paper (thicker than 350 gsm), you might
experience misfeeds. Should this happen, refer to "Misfeed / Jam in Vacuum Trays when
feeding thick media" in section 5 of this manual. As a general rule, use tray 3 (the upper
tray) or tray A (the optional LSM tray) to feed thick media.
